 |
 |
|
|
| Changed: |
<
< |
| >
> |
- IC14 - 515 XHigh Side Switch MUST USE 5151's OR EQUIVALENT on this board revision. 5050s will throw VTS code.
|
|
|
| Added: |
>
> |
(Note: I've noticed that IPT bd. 11F0-1500 automatic does not utilize Q27 or Q28, you must use transistors from some other source.) |
|
|
| Added: |
>
> |
to convert non-vtec "11F0" boards from non-vtec to vtec, add:
|
| Changed: |
<
< |
94-95 PO6 with 11F0 board
| >
> |
In top left quadrant:
- C60 - 1uF, 35v electrolytic (tantalum?) capacitor
- J10 - 0 Ohm jumper wire
- Q101 - A143 PNP switching transistor
- R201 - 10K resistor (Brown-Black-Orange-Gold)
- IC14 - 515 XHigh Side Switch
- D11 - Clamping Diode
|
| Changed: |
<
< |
M/T
-Add 1uf electrolytic tantalum capacitor @ C60
-Add 0 ohm jumper @ J10
-Add A143 transistor @ Q101 ( b1030 PNP)
-Add 5151s high side switch @ IC14
-Add a 1n4001 diode @ D11
Remove J3 and J5 if present (J4 should remain)
| >
> |
This is an evolution of the "1720" board design. Things are simpler, as is evidenced by the conversion having fewer components than the 02 D01720-1500 conversion.
Automatic P06 ECUs have SK-5151 high side switches, just in different spots. Desolder them both. Use one for conversion, and save the other one. The A143 transistor @Q101 can be taken from Q28 or Q27.
|
| Deleted: |
<
< |
A/T
-Automatic ECUs have 5151s high side switches, just in different spots.
Desolder them both, use one and save the other one.
-Add A143 transistor @ Q101 ( B1030 PNP) (you can use them from q28&q27)
-Remove RP17 and RP18
-Add a 0 ohm jumper @ RP18 |
|
|
| Added: |
>
> |
%META:TOPICINFO{author="crxsirvtec" date="1079106600" format="1.0" version="1.1"}%
%META:TOPICPARENT{name="NonVtec-To-Vtec"}%
94-95 PO6 with 11F0 board
M/T
-Add 1uf electrolytic tantalum capacitor @ C60
-Add 0 ohm jumper @ J10
-Add A143 transistor @ Q101 ( b1030 PNP)
-Add 5151s high side switch @ IC14
-Add a 1n4001 diode @ D11
Remove J3 and J5 if present (J4 should remain)
A/T
-Automatic ECUs have 5151s high side switches, just in different spots.
Desolder them both, use one and save the other one.
-Add A143 transistor @ Q101 ( B1030 PNP) (you can use them from q28&q27)
-Remove RP17 and RP18
-Add a 0 ohm jumper @ RP18 |
|
Copyright © 2002-present by the contributing authors. All material on this collaboration platform is the property of the
contributing authors, and is covered by the Non-Commercial Share-Alike License unless explicitly stated otherwise. |
|