|
Peak And Hold Injectors aka Low Impedance Injectors.
Impedance typically ~2-5ohms.
At 12volts, this is a draw of ~6-2.4 amps
The high current will cause the injectors to run hotter.
The peak current opens the injector "crisply" and decisively. Then a lower "Hold" current keeps the injector open.
To run these injectors with the honda ecu, you may need to use an inline Resistor Box.
OBD0 already has a resistor box wired in.
OBD1 does not have a Resistor Box.
OBD2 does not have a Resistor Box.
|
Copyright © 2002-present by the contributing authors. All material on this collaboration platform is the property of the
contributing authors, and is covered by the Non-Commercial Share-Alike License unless explicitly stated otherwise. |
|